Dodge the Teapots of Doom

Dodge the Teapots of Doom (currently under the name as Classic Dodge the Teapots of Doom) is place created by Clockwork. It is similar to an obby. The game sounds easy: you must dodge oversized teapots without falling off or dying. However, it is not as easy as it looks, with only several small platforms to dodge the incoming teapots. If you reach the end you are teleported to a safe platform, which is in the sky above the teapots. The teapots will also increase their level of difficulty (and occasionally lower it).

Tips[]

Try to get around the teapots, rather than over or under.
Never jump on a person's head for a boost. You'll either: Fall off, get hit by a teapot (Both flying and rolling), or jump on top.
Try not to fall off the safe platform when you get there.
Remember to dodge the handle of the teapot; it is a common mistake to dodge the teapot itself but not the handle.
It's not always safe on the safe platform; if the teapots have a high enough level, a teapot may fly onto the platform, killing everyone on it.
Hide behind one of the small walls and wait until the coast is clear. Then you run as fast as you can near the side of the stage. If a pot is coming, turn back.

Trivia[]

This section is a trivia section. Please relocate any relevant information into other sections of the article.

The teapot mesh is based on an infamous modified version of the Utah Teapot (or the Newell teapot) made in 1975 by Martin Newell.
This is one of the first games on Roblox to have a custom Mesh.